Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Now you can begin attaching accessories and securing
the cord into place.
- Please note the following steps can be completed in any
order and you may place the clips and accessories in any
of the grooves you choose below the glass vanity tray. The
diagram shown is a representation of one way you may
choose to set up your floor stand mirror.
Fig.8
step 1
step 2
select
K
position
Fig.8a
repeat steps 1, 2, and 3
for attaching towel bar.
step 3
I
12
11. (Fig. 8) Select the position on
the stand where you want
your Hair Dryer Caddy to be
located [step 1]. Snap an
Attachment Clip K [step 2]
onto the groove in the pole.
Slide the Hair Dryer Caddy I
over the Clip [step 3], ensure
the groove is facing upwards
when doing so. The Caddy
is securely in place when
you can no longer see the
Attachment Clip from the top
or bottom of the Caddy.
- To attach the Towel Bar
Holder repeat [step 1,2,3]
(Fig. 8a).
12. (Fig. 9) To secure the Cord
to the pole, snap the three
Cord Clips F into the pole
grooves, spacing them apart
as shown. Slide the Cord
into the three Clips at each
location until each is held
securely in place (Fig. 9a).
13. Remove the protective
plastic coating from
mirror face.
Fig.9
13
F
Tabla de contenido
