FLAEM Primo Neb Manual De Instrucciones página 11

the device under running water or submerge in water. Keep away from splashing water
or other liquids.
• Do not expose the device to high temperatures.
• Do not put the device near heat sources, direct sunlight, or in hot environments.
• Do not obstruct or insert any objects in the filter or in its housing.
• Do not obstruct the air vents placed on both sides of the unit.
o
• During use, always place the unit on a firm surface clear of obstacles.
ts
• Check that there is no material obstructing the air vents before each use.
• Do not place any objects inside the air vents.
s
• The average duration provided for compressor ranges is: F400: 400 hours, F700: 700
n
hours, F1000: 1000 hours, F2000: 2000 hours.
e
• Repairs must be performed by authorized personnel only. Any unauthorized repairs will
void the warranty and may pose a safety hazard for the user.
WARNING: Do not modify this equipment without authorization of the manufacturer
• The Manufacturer, the Retailer and the Importer are responsible for the safety, reliability
and performance of the device only if: a) the device is used in accordance with the
operating instructions b) the electrical system of the premises where the device is used
is in compliance with current laws.
• Interactions: The materials used that come into contact with medications have been
tested with a wide range of medications. However, due to the variety and continuous
evolution of medication, the possibility of a chemical interaction cannot be excluded.
We recommend that once the medication has been opened you should use it as soon
as possible and avoid prolonged contact of the medication with the nebulizer.
• The manufacturer should be contacted for reporting problems and/or unexpected
events related to device operation.
OPERATING INSTRUCTIONS
fe,
Before each use, clean hands thoroughly and clean the device as described in the
no
section on "CLEANING SANITIZATION DISINFECTION". During use, it is advisable to
an
protect yourself from any dripping. It is recommended that each person use their
own nebulizer cup and accessories to prevent risk of infection due to contamination.
ace
During application it is advisable to suitably protect yourself from any dripping.
to
1. Plug the power cord (A5) into a power socket corresponding to the voltage of the unit.
an
This must be positioned so that it is not difficult to make the disconnection from the
mains.
ore
2. Insert the nozzle (C1.2) in the upper part (C1.3) pressing as shown by the 2 arrows in
the "Connection diagram" in point C1. Insert the Speed selector (C1.4) in the upper part
ed
(C1.3) as shown in the "Connection diagram" in point C1. Pour the medication prescribed
en
by the doctor into the lower part (C1.1). Close the nebuliser by turning the upper part
he
(C1.3) clockwise.
3. Connect accessories as indicated in the "Connection diagram" on the cover.
ith
4. Sit comfortably holding the nebuliser in your hand, place
the mouthpiece onto your mouth or alternatively use the
nose piece or mask. Should you opt for the mask accessory,
place it on your face as shown in the picture (with or
without using the elasticated strap).
nts
5. Turn on the device using the switch (A1) and then breathe
his
in and exhale deeply.
ice
6. When the treatment is finished, shut off the device and
an
unplug the power cord.
WARNING: If after the therapy session moisture accumulates
ed.
in the tube (B), remove the tube from the nebulizer and dry it using the device's
ash
9