Key Functions - MasterCool 98310 Manual De Instrucciones

WIRELESS REFRIGERANT CHARGING SCALE
WIRELESS REFRIGERANT CHARGING SCALE WITH SOLENOID
A. Notice: The changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
B. IMPORTANT NOTE: To comply with the FCC RF exposure compliance requirements, no change to the
antenna or the device is permitted. Any change to the antenna or the device could result in the device
exceeding the RF exposure requirements and void user's authority to operate the device.
C. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.

KEY FUNCTIONS:

SYNC:
UNITS/SHIFT:
CHARGE/PAUSE: CHARGE - To start CHARGE/RECOVERY mode
TARE/ENTER:
REPEAT:
CLEAR:
CHECKLIST (Prior to 1st use)
Install battery in both platform and monitor. Place the platform on a flat surface and press the
ON/OFF button on the platform and monitor to turn unit on. Proceed to BASIC or PROGRAM
CHARGING.
PLEASE NOTE: After turning ON the scale or replacing batteries, there will be a 3 second delay
in displaying the scale's battery level, if the power LED in the scale remains on (without blinking),
the scale has normal working status.
* If the digital readout displays a small weight (±.5 ounce or ±20 grams) press and hold the
TARE/ENTER button for approximately 3 seconds until you hear a DOUBLE BEEP. The scale will
automatically zero out. Proceed to BASIC or PROGRAM CHARGING.
2
OPERATING INSTRUCTIONS
Turns unit ON or OFF
To synchronize platform with monitor
UNITS - Select readout in lb, oz or kg
SHIFT - Move from one digit to the next, to edit display, to set up tank
capacity
To increase value
To decrease value
PAUSE - To pause and resume in CHARGE/RECOVERY mode
TARE - Zeros out display in BASIC CHARGING
ENTER - To start operation or input data
To repeat the last action
Use to clear the display during PROGRAM CHARGE ONLY. (Do not use clear
for any other function!)
www.mastercool.com
English