Ingersoll Rand Expert Torque Analyzer Manual Del Usuario página 13

Angle or
Pulse Count
Mode Selected
(as an icon)
Direction of
Applied Torque
Transducer Range
Transducer Type
T ransducer Serial Number
Return to Previous Screen
Change the "Quick Store" Settings
From any mode-specific Quick Store screen, press
any of the 9 preset Transducer Templates that have already been created by pressing
as needed by using the
Quick Read, the following settings are also available under Quick Store, although the settings available will vary according to the chosen meas-
urement mode as well as the type of transducer being used.
Change the Torque USL (Upper Specification Limit): Key in the required figure and press
Change the Target Torque: Key in the required figure and press
Change the Torque LSL (Lower Specification Limit): Key in the required figure and press
NOTE: The Torque USL & LSL can be displayed as either a torque value or as a percentage above or below the Target. To change, high-
light the desired option and press
Change the 2 Parameter USL (Upper Specification Limit): Key in the required figure (between the max. and min. displayed on screen)
nd
and press .
Change the 2 Parameter Target: Key in the required figure (between the max. and min. displayed on screen) and press
nd
Change the 2nd Parameter LSL (Lower Specification limit): Key in the required figure (between the max. and min. displayed on screen)
and press .
NOTE: The 2 Parameter USL and LSL can be displayed either as a value or as a percentage above or below the Target value. To change,
nd
highlight the desired option (radio button) and press
Return to the Quick Store Tab: Press
View additional Quick Store Settings: Press
Choose preset Transducer Template: Press
Template
45652906_ed1
Table 7- Status LED & Buzzer
Torque /Angle/Pulse Value
Above USL
Below USL & Above LSL
Below LSL & Above Threshold
Below Threshold
Figure 13 – Pulse Mode Quick Store screen
Quick Store
# of Stored
Readings
004
30.00 Nm
UTA
S / N = 27916
1
�
Quick Store
Settings
to access the corresponding Quick Setup screen. From here, the user can either select
and the key to highlight & select the desired setting. In addition to the same settings found under
.
to return to the Quick Store Tab.
DEF
or to go to the next/last set of Quick Store settings.
3
to access the Transducer Templates. Highlight and select your desired preset Transducer
GHI
4
LED Color
Red
Green
Amber
No Change
04-02
.
2.04
33
3.59
Nm
0.2 s
180
542 Hz
2 3 4
X
Autoprint
Autostore
Pulse per
On/O
On/O
Revolution
GHI or you can change the individual transducer settings
4
.
.
# of Beeps
3
2
1
0
Screen Number
Time
Torque Applied
Displayed Units
Cycle End Time
Frequency Response
5
View
Readings
.
.
EN
.
EN-12