Insert Locking Hose; Hose Assembly - Craftsman CMXEVBE175850 Manual De Instrucciones

Insert Locking Hose (Fig. H)
NOTE: Use ONLY the Metal Lined Hose and Metal
Accessories provided with this Ash Vacuum.
1. Align Hose Tabs with Vacuum Inlet and insert the
Locking End of the Hose into the Vacuum Inlet of the
Vacuum Drum, as shown.
2. Rotate the Hose clockwise to lock into place.
3. To remove the Hose from the Vacuum, rotate the
Locking Hose Counterclockwise and pull the Hose out
of the Vacuum Inlet.
Fig. H
Hose Locking End
Locking Hose
(Metal Lined)
with LED Light
SP7088-2 CMXEVBE175850.indb 9
Hose Assembly (Figs. I & J)
1. Slide the Round End of the Extension Nozzle into the
Fig. I
2. Loosen the Two LED Assembly Screws, located at the
3 Slide the Wand Nozzle through the LED Assembly and
Inlet
4. Retighten the Two LED Assembly Screws to secure the
ROTATE HOSE
CLOCKWISE
TO LOCK Fig. J
smaller Tapered End of the Wand Nozzle.
Wand
Nozzle
bottom of the LED Lighted Nozzle.
into the Rubber Hose Fitting.
LED Assembly to the Hose Assembly.
Screws (2)
LED Lighted
Wand Nozzle
Nozzle
Extension
Nozzle
9
10/24/19 11:59 AM