Led Lighted Nozzle Usage; Led Lighted Nozzle Battery Replacement - Craftsman CMXEVBE175850 Manual De Instrucciones

LED Lighted Nozzle Usage (Fig. K)
1. Press Button to activate LED light while Vacuuming.
2. Slide the Switch Forward to Lock the LED Light in the
ON position.
3. Slide the Switch Back to the OFF position after use.
Fig. K
10
SP7088-2 CMXEVBE175850.indb 10

LED Lighted Nozzle Battery Replacement

(Fig. L)
1. To access Batteries, remove and retain the Battery
Access Panel Screw.
2. Remove and retain the Four Screws from the LED
Assembly, releasing the Switch Button Module.
3. The Two Batteries are located under the Switch
Button module. Dispose Batteries in the proper waste
LED Button
disposal container.
4. The LED Light uses Two CR2016 Lithium Batteries that
are replaceable.
5. Reposition the Switch Button Module over the Battery
Compartment. Install the previously removed Four
Screws into the Switch Button Module to secure.
6. Reposition the Battery Access Panel over the Switch
Button Module. Install the previously removed Screw
into the Battery Access Panel to secure.
LED
Assembly
Fig. L
Screw (1)
Battery
Access
Panel
Screws (4)
!
WARNING:
Keep batteries out of reach of small children. Consult
a physician immediately if a battery is swallowed.
Severe burning or injury may occur.
Battery contains Perchlorate Material - Special handling
may apply.
See www.dtsc.ca.gov/hazardouswaste/perchlorate.
Switch
Button
Module
CR2016
Lithium
Batteries
(2)
LED
Assembly
10/24/19 11:59 AM