Setting Up; Operation; High Power Mode - Henry Schein HS-CU 1000 Instrucciones De Uso

SETTING UP :

(1) Unpack the curing light. Place on firm flat surface or wall mount if preferred.
(2) Insert the fiber optic probe into the handpiece until firmly seated. Attach the protec-
tive shield onto the probe if required.
(3) Securely place the handpiece on the rest.
(4) Plug the unit into an AC outlet within a range from 100V to 240V. (**The machine oper-
(5) The HS-CU 1000 light curing system is ready for use.
ates with a universal power supply)

OPERATION :

(1) Turn on the power switch located on the left side of base unit.
(2) The LEDs lights will run through a power up test. When the test is completed, a
"beep" sound will confirm. The unit will retain previous curing mode set up in
memory.
(3) Apply composite in mm's as indicated by composite manufacturer. Select curing
mode to begin curing process.

HIGH POWER MODE :

By pressing the "HIGH POWER" button, you will have 3 choices of curing time- 5 sec.,
10 sec., and 20 sec. – all working at full strength.
**The curing cycles are activated by pressing the trigger switch on the handpiece, which
simultaneously activates the magnetic fan for cooling.
5 sec. – The curing cycle ends with a "beeping" signal at 5 seconds, but the fan
running will continue its automatic cooling phase (varies from mode to mode).
10 sec. – A "beeping" signal is sounded at 5 second intervals before the auto
shutdown.
20 sec. – A "beeping" signal is sounded at 10 second intervals before the auto
shutdown.
1