Instructions - Henry Schein ALGINATE MIXER 2010 Instrucciones De Uso

4

INSTRUCTIONS :

Mixing alginate:
1) Turn on the main switch on the
back of the machine (Fig.3) An
LED indicator will light on the left
side of the control panel and the Henry Schein Alginate Mixer is ready for operation.
IMPORTANT: The unit is not suitable for use in the presence of flammable mixtures.
2) Press "POWER" on/off button on the control panel to display time indicator showing
digital pre-set mixing time (Fig.4)
CAUTION:
- Always keep the equipment in a sleep mode with "the time display is off" when not in use.
- Do not operate empty. The Henry Schein Alginate Mixer is designed to operate
when material is in the Mixing bowl. No impression material, no operation!
3) Measure the appropriate amount of powder using the scoop and instructions sup-
plied with the chosen alginate material.
NOTE: Before dosing, agitate the alginate powder to loosen it well. Scoop it from the
storage box with a light, swift movement and then stroke the powder smooth: do not
compress the powder in the scoop.
4) Using the water dosing bottle or a beaker measure the appropriate amount of cold
water at room temperature (10~20°C). Add water to the alginate in Mixing bowl.
IMPORTANT: The setting time of
alginate can be controlled by dif-
ferent water temperature. Care
should be taken as setting time
will be shortened if cold water is
not used, particularly in summer.
5) Follow to the instruction of the
recommended mixing ratio for a
better consistency of impression.
You can make the mixture thinner
(higher viscosity) by adding more
or less water respectively (Fig.5).
6) Stir the alginate powder and water
together in the Mixing bowl for about 2 seconds before placing it into the mixing well
(Fig.6). The user can alternatively, shake the cup a few times for preliminary mixing before
placing it into the mixer if not using the stirrer provided. Skipping this pre-mix step may
result in poor mixing or imperfect consistency of mixture.
HINT: Scrape the stirrer along the edge of mixing bowl to remove excess material and
avoid any residual staining.
7) Close the lid of the Mixing bowl tightly. Ensure the small hole in the centre of the lid
is not blocked. (Fig.7/Fig.8)
IMPORTANT: The Mixing bowl lid must be
closed tightly; otherwise spillage or splash may
occur or separated lid may hit against the cover.
The Mixing bowl lid is replaceable, please
renew if it becomes loose fitting.
Fig.3
Fig.5
Fig.7
Turn
Fig.4
Fig.6
Fig.8