Environmental Conditions For Installation And Use - Henry Schein ALGINATE MIXER 2010 Instrucciones De Uso

6. Should any abnormal noise or vibration occur while in mixing, press the START/STOP
button immediately and lift the cover to check contents.
7. The Mixing bowl is replaceable. Renew if damage or difficulty in closure is experienced.
8. There are two retention bolts (for immobilisation) at the base of the unit, these should
be removed before use and replaced if the unit is moved or sent for repair, (Fig.1)
this prevents unnecessary damage during transit.

ENVIRONMENTAL CONDITIONS FOR INSTALLATION AND USE :

1. Conditions for installations and use:
1) For indoor use only.
2) Operating ambient temperature is between 2°C ~ 40°C (35.6 ~ 104°F).
3) Operating altitude is below 2000 metres and atmospheric pressures between 900 ~ 1600 millibars.
4) Relative Humidity is lower than 80%.
5) Operating area should be free of dust, acids or solvent vapours.
2. Installation:
1) The Henry Schein Alginate Mixer should be positioned on a firm, flat, vibration free surface.
2) Never install near to inflammable substances.
3) Keep away from water or moisture to avoid electric shock or mechanical problems.
4) Do not place anything on the cover or control panel to avoid any damage or spillage.
3. Before/After Transportation:
1) Before installing the Henry Schein Alginate Mixer remove the two bolts fixed at the
bottom and follow the instruction (Fig.1) to store them safely.
2) If the mixer needs to be moved or sent for repair, replace the bolts to immobilize the
motor to prevent possible malfunction or damage.
4. Power:
1) Check the power switch on the back of the unit is off, and
then connect the power cord to the voltage adaptor. (Fig. 2)
2) Plug into a standard AC inlet with 6.3 Amp fuse with a
Certificated power supply cord H03 VV-F or H03 VVH2-F,
the power cord set shall have a cross-sectional area of
3x0.75mm 2 min.
DANGER:
- Check to see the Henry Schein Alginate Mixer's voltage requirement matches your
power source. Damage to the Henry Schein Alginate Mixer, electric shock, or fire
may occur if voltages are incompatible.
- Keep any potentially dangerous substances a minimum of 30cm (1ft) radius from the
Henry Schein Alginate Mixer.
- Ensure that hand and body are dry when touching power socket, main switch or
operating the equipment.
3
Fig.1
Fig.2