Tabla de contenido
Nearly all commercially available descaling products are appropriate for use. The instructions on most
products indicate whether they are suitable. Never use any product containing hydrochloric or sulphuric
acid. These are not suitable for descaling.
Proceed as follows:
- First allow the appliance to cool down sufficiently.
- Fill the reservoir with cold water.
- Add some descaler to the water as indicated on the packaging
- Place a filter paper in the permanent filter, not forgetting to put the pot in place.
- Switch on the appliance.
- Once about 2 cups have flowed through, switch off the appliance and let it stand for a half-hour to
allow the descaling agent to work. Switch on the appliance again. After all of the water with descaling
agent has flowed through, brew clean water through it three times to rinse away any remaining traces
of descaling agent.
NOTE: Let the appliance cool down for about three minutes in between rinse cycles. The warranty does
not apply to appliances with calcified build-up.
PRINCESS TIPS
- Set the appliance on a sturdy, stable surface.
- Never immerse the appliance in water or any other liquid.
- The exterior can become quite hot. Only pick up the pot using the handle.
- Ensure that the appliance is not so close to the edge of a table, counter top, etc., that someone could
knock it over. Do not allow the cord to hang over the edge or on the floor, as someone may become
entangled or trip over it. Remember: the appliance contains hot water!
- Do not use the equipment if it is damaged, or if the lead is damaged. Send it to our Service
Department. With this type of appliance, a damaged lead should only be replaced by our service
department using special tools.
- Do not place the appliance on or directly adjacent to a warm hotplate or other source of heat.
- Always unplug the appliance before cleaning or if any fault develops.
- The hotplate gets very hot. Ensure that children cannot reach it and be careful yourself.
U.K. WIRING INSTRUCTIONS
The wires in the mains lead are coloured in accordance with the following code:
BLUE
BROWN
GREEN/YELLOW
As the colours of the wire in the mains lead of this appliance may not correspond with the colour mar-
kings identifying the terminals on your plug, proceed as follows:
The wire which is coloured BLUE must be connected to the terminal which is marked with the letter N or
coloured black.
The wire which is coloured BROWN must be connected to the terminal which is marked with the letter L
or coloured red.
The wire which is coloured GREEN/YELLOW must be connected to the terminal which is marked with
the letter E or
and is coloured GREEN or GREEN/YELLOW
WARNING: THIS APPLIANCE MUST BE EARTHED
NEUTRAL
LIVE
EARTH
5
Tabla de contenido
