Caring For The Steam Bath/Shower Cabin - HOESCH SteamSet Instrucciones De Montaje

— Please note that in the shower enclosure area only appropriate materials for wall covering must be used.
A ground surface treatment according to moisture stress class FKB 2 is required.
— Before installation the walls must be completely tiled at the entire cabin hight.
— The ground surface at the installation location must be perfectly flat.
— A ventilation as well as sufficient air dehumidification in the installation room are to be ensured. If necessary,
please apply a suitable ventilation appliance for water vapour dissipation in a controllable manner
(DIN 18017, DIN 1946 etc.).
Silicone must be provided by building constructor. Please keep in mind that maintenance joints may require
cleaning.
03 Caring for the steam bath/shower cabin
After showering/steaming, rinse the tray and wall element surface with water and wipe down with a damp cloth. Do not
use scouring agents! For occasional thorough cleaning, use a few drops of cleaning agent, e.g. Hoesch Cleaner (item
no. 6999 00), on the surface and rub with a soft, dry cloth. Remove heavier soiling using warm water and liquid cleaning
agent or a soap lye. Wipe away scale deposits using vinegar and water (avoid contact with the fittings!). Observe the
manufacturer's instructions if using drain cleaners!
Remove slight scratches or rough areas in glossy surfaces with the Hoesch Sanicryl care set (item no. 6991 00, follow
instructions!). Remove deep scratch marks or burns on glossy or matt surfaces using fine sandpaper (no. 500) or a fine
steel wool metal eraser by rubbing carefully in one direction in a large area around the scratch. Treat glossy surfaces
only with special polishing cream.
GB
03.01 Caring for the glass panes and profiles
■ After showering, quickly rinse the partition with clean water.
■ Use only a damp rag (never dry) to wipe down the panels and frame. You can also use a squeegee to dry
the panels.
■ Only use gentle cleaners such as a weak vinegar and water solution. Never use cleansing powder or cleaners
containing chlorine.
■ Do not use microfiber cloths. They destroy any coatings and may cause the glass to become scratched.
■ It is a good idea to lightly oil sliding and swinging doors so they remain easy to open.
03.02 Caring for the fittings
For day-to-day cleaning, use neutral or citrus-based cleaning agents only. Use cleaning agents intended for cleaning
fittings only. Follow the instructions for the cleaning agent!
Spray cleaning agent onto a cloth and use it to clean the fittings.
Rinse the fitting with plenty of water and polish with a soft cloth.
03.03 Do not use ...
■ Scouring or scraping cleaning textiles or sponges.
■ Cleaning agents with fluid acids such as hydrochloric or citric acid.
■ Scouring agents.
■ Cleaning agents containing chlorine bleach lye.
6