Idiomas disponibles
Idiomas disponibles
4. Safety instructions
• This product is intended for private, non-
commercial use only.
• This product is intended exclusively for installation
in suspended ceilings or suitable built-in recesses
or concrete built-in housings.
• Use the product only for the intended purpose.
• Do not drop the product and do not expose it to
any major shocks.
• Do not operate the product outside the power
limits speci ed in the technical data.
• Do not modify the product in any way. Doing so
voids the warranty.
• Children must not play with the device. Cleaning
and user maintenance must not be carried out by
children without supervision.
• As with all electrical products, this device should
be kept out of the reach of children.
• Dispose of packaging material immediately
in accordance with the locally applicable
regulations.
• The product should only be installed in self-
contained rooms. It is not suitable for installation
in bathrooms.
• The product must only be operated on a supply
network as described on the type plate.
• Before mounting, check that the ceiling you have
chosen is suitable for the weight to be mounted.
Also make sure that there are no electric, water,
gas or other lines running through the ceiling at
the mounting site.
• Electrical cables must never become trapped or
twisted between the product and the surface.
• If the product is attached to a metal surface,
it must be connected to an earth lead or the
installation's potential equalising cable.
• These built-in lights are not compatible with
dimmer switches, motion sensors or dimmers.
• Protect the product from dirt, moisture and
overheating and use it in dry rooms only.
• Only use the article under moderate climatic
conditions.
• Do not use the product in areas in which
electronic products are not permitted.
• Do not use the product in a damp environment
and avoid splashing water.
• Do not bend or crush the cable.
• Do not attempt to service or repair the product
yourself. Leave any and all service work to
quali ed experts.
• Do not continue to operate the device if it is
visibly damaged
Warning
• Please note that lights (even LEDs) can gene-
rate heat and may become hot. Always let
the light cool down for a few minutes before
touching it.
• The device can only be operated on a 230
V / 50 Hz AC voltage network. Work on the
230 V network must only be carried out by
an electrician certi ed in your country. The
applicable accident prevention regulations must
be adhered to.
• To avoid an electric shock from the device,
please disconnect the mains voltage (switch off
the automatic circuit breaker). Failure to comply
with the installation instructions can cause res
or other hazards.
Risk of electric shock
Do not open the product and do not operate it if
it is damaged, if smoke, a strange smell or loud
noises are coming from it. Immediately contact
your dealer or our service department (see item
"Service and Support").
Note
The light source of this light is not replaceable;
when the light source has reached the end of its
life, you need to replace the entire light.
Warning
Never look straight into the light source and do
not aim its beam of light straight into the eyes
of other people or animals. This could damage
your/their eyes.
5
