Troubleshooting Guide; Spécifications Techniques - Shark CV520C Manual Del Usuario

FAMILIARISEZ-VOUS AVEC VOTRE ASPIRATEUR
TRAÎNEAU
1. Bouton d'alimentation On/Off
2. Poignée
3. Bouton de rembobinage du cordon
4. Indicateur de sac plein
5. Couvercle
6. Onglet de blocage du couvercle
7. Entrée d'air
Spécifications techniques
Tension : 120 V, 60 Hz
Intensité : 10 A
Les illustrations peuvent différer du produit lui-même.
8. Roues arrières à glisse facile
9. Tubes de rallonge (2)
10. Brosse plancher-à-tapis
11. Sacs à poussière
12. Boyau souple
13. Commande de succion manuelle
18
TROUBLE SHOOTING GUIDE

TROUBLESHOOTING GUIDE

PROBLEM POSSIBLE REASON
1. Hose, wand or inlet is
blocked.
Motor runs but no
2. Check bag full indicator.
suction
3. Hose clamp not assembled to
hose inlet properly.
1. Cord twisted.
Cord does not
2. Cord pulled out too far -
rewind
beyond "RED" mark.
1. Not firmly plugged in.
2. Blown fuse/tripped breaker.
Cleaner won't run
3. Motor thermostat may have
tripped.
ORDERING REPLACEMENT FILTERS & BAGS
TO ORDER REPLACEMENT FILTERS & BAGS
OR FOR TECHNICAL SUPPORT
FOR MODELS CV520C – CV520Y-CV520R-CV520B
Call:
Monday to Friday 8:30 A.M. - 5:00 P.M. Eastern Standard Time
IMPORTANT: DO NOT ATTEMPT TO WASH or REUSE DUST BAGS.
Always replace with new dust bag to keep your unit in maximum working
condition.
Please Note:
The Pre-Motor and Post-Motor Filter are washable. It should however be
replaced every Three (3) to six (6) months, depending on usage, to ensure
peak performance of your vacuum. Make sure that the Pre-Motor and
Post-Motor Filters are completely air-dried for 24 hours before inserting
back in the vacuum.
POSSIBLE SOLUTION
1. Check for blockage - remove it.
2. If dust bag is full, replace dust
bag or look for blockages in
system or vacuum.
3. Insert hose clamp into hose inlet
until "snap" locks for proper
assembly.
1. Pull cord out, straighten and
rewind again.
2. Holding the plug, press the
rewind button and try to rewind
again.
1. Plug unit in firmly.
2. Replace fuse/reset breaker.
3. Allow unit to cool down before
trying to switch "ON" again.
1 (800) 798-7398
7