Stihl HT 75 Manual De Instrucciones página 73

Replacing the Starter Rope
7
Use a screwdriver to pry the cap (6)
N
out of the starter grip.
Remove the remaining rope from
N
the rotor and grip, making sure the
ElastoStart sleeve is not pushed out
of the grip.
Tie a simple overhand knot in the
N
new rope and then thread it through
the top of the grip and the rope
bushing (7).
Refit the cap in the grip.
N
HT 75
6
Thread the rope through the rotor
N
and secure it with a simple
overhand knot.
Go to "Installing the Rope Rotor".
N
Replacing a Broken Rewind Spring
Two types of replacement springs are
available from the factory:
A ready-to-fit rewind spring secured
–
with a wire retainer.
A rope rotor with pre-installed
–
rewind spring.
Installing the ready-to-fit rewind spring
Lubricate the spring with a few
N
drops of resin-free oil – see "Special
Accessories" – do not open the wire
retainer!
Carefully remove the parts of the old
N
spring from the starter cover and
rope rotor.
Insert the new rewind spring in the
N
rope rotor and, at the same time,
engage the outer spring loop in the
rotor's recess – the wire retainer
slips off in this process. If the spring
pops out and uncoils, refit it in the
counterclockwise direction, starting
outside and working inwards.
Go to "Installing the Rope Rotor".
N
Installing rope rotor with rewind spring
Carefully unpack the new rope rotor
N
with rewind spring. The spring may
pop out if not handled with care –risk
of injury.
Lubricate the spring with a few
N
drops of resin-free oil – see "Special
Accessories".
Go to "Installing the Rope Rotor".
N
Installing the Rope Rotor
a
a = 2mm
(0.08 in)
Check dimension "a" for inner
N
spring anchor loop and bend it
slightly if necessary.
Coat rope rotor bearing bore with
N
resin-free oil – see "Special
Accessories".
English
71