Saving The End Position By Means Of A Teach-In Run; Unteaching The Remote Control; Teaching And Unteaching Additional Remote Controls; Forming Of Groups - hafele E-Senso Manual De Instrucciones

4.2

Saving the end position by means of a teach-in run

In the next step, the end position of the flap for each opening direction is
determined by pressing the remote control and carrying out a teach-in run,
see illustrations on page 76.
4.3

Unteaching the remote control

For step-by-step instructions "Unteaching the remote control", see
illustrations on page 77.
4.4

Teaching and unteaching additional remote controls

Up to 5 remote controls can be taught and untaught again on a control unit,
see illustrations on page 78.
To do this, repeat operations from chapters 4.1 and 4.3 for each remote
control. If more than 5 remote controls are taught, the oldest remote controls
in the control unit are overwritten.
4.5

Forming of groups

A remote control can be matched to several control units. In this way several
control units can be operated at the same time as a group, provided that all
control units are within reach of the remote control, see illustrations on
page 78.
NOTE
In case a control unit does not receive a switching command it can happen
that the connected cabinet flap moves in the opposite direction. Continu-
ously pressing the button of the remote control closes all connected cabi-
net flaps.
5.

Resetting settings in the control unit

Resetting the control unit to the factory settings deletes all taught remote con-
trols.
NOTE
If a remote control has been taught accidentally and a cabinet flap moves
for no apparent reason or a remote control is lost / defective, reset the control
unit.
For step-by-step instructions "Resetting the setting", see illustrations on page 80.
20/84