Important; Safety Regulations; General Description; Description Of The Apparatus - Elettro CF CU06H Manual De Instrucciones

IMPORTANT:

BEFORE USING THIS DEVICE ALL PEOPLE AUTHORIZED
TO ITS USE, REPAIR OR INSPECTION, SHOULD READ
THIS MANUAL, PAYING SPECIAL ATTENTION TO THE
SAFETY RULES. CONTACT YOUR DISTRIBUTOR IF YOU
HAVE NOT UNDERSTOOD SOME INSTRUCTIONS.

1 SAFETY REGULATIONS

1.1 Introduction
Before using this device, all persons authorized to operate,
repair or inspect the unit must read the following safety and
operating instructions :
Remember: YOUR SAFETY DEPENDS ON YOU !
The operator is responsible for his own safety, and for that of
other persons in the working area. He must therefore be
aware of, and respect, all safety regulations.
NOTHING CAN REPLACE COMMON SENSE!

2 GENERAL DESCRIPTION

2.1. Specifications
This apparatus is a self-contained cooling unit, designed to
cool the torches used in TIG, MIG, MAG welding and plasma
cutting equipments.
2.2. Explanation of the technical data
1~ Single-phase input voltage
U .....V Rated input voltage.
1
50 - 60Hz
Frequency
I .......A Maximum absorbed current
1
2.3 Description of protections
2.3.1. "Coolant pressure" protection
This protection is created by a pressure switch, fitted on the
coolant delivery circuit, which controls a microswitch fitted.
N.B.: To use this protection, connector (E) must be inserted in
the welding or cutting generators special socket.

2.4 Description of the apparatus

A) ON/OFF switch
B) Tank cap.
C) Slot for checking the coolant level.
D) Mains lead.
E) "Coolant pressure" protection connector.
J1-J2) Rapid joints for the torch cooling tubes.
INSTRUCTION MANUAL FOR COOLING UNIT
4