Listening To The Radio - Brandt BCR160P Manual De Instrucciones

6. Whilst the hour format is flashing, press
24 hour display.
7. Press SET/MEM to confirm.
• The hour digit will flash on the display.
8. While the hour digit is flashing, press or press & hold
until the desired hour appears. Press SET/MEM to confirm.
• In 12 hour format a "PM" indicator will appear for PM time.
• The minute digits will flash on the display.
9. While the minute digits are flashing, press or press & hold
until the desired minutes appear. Press SET/MEM to confirm.
POWER ON/RADIO MODE
Press to switch the unit on and enter the radio mode.
• The radio frequency will briefly appear on the display and then
return to clock time.
LISTENING TO THE RADIO
1. Tune in to the desired station by repeatedly pressing
• The wire aerial located on the rear of the unit is for FM
reception. The wire should be fully extended and positioned
for optimum reception.
• Press and hold
button, the unit will scan the frequencies until a broadcasting
station strong enough for good reception is found.
2. Adjust the volume by pressing or pressing & holding
3. The radio can be switched off by pressing
PRESETTING YOUR FAVOURITE RADIO STATION
Up to 10 FM radio stations can be preset.
1. Follow steps in "LISTENING TO THE RADIO" and tune in to the
station that you wish to preset.
2. Press and hold M+/NAP for 2 seconds, "P01" will flash on the
display.
3. Repeatedly press
4. Press M+/NAP again to store the station.
5. Repeat steps above to store desired stations.
To listen to preset radio stations, repeatedly press M+/NAP to select
the desired radio station.
/ for 2 seconds and then release the
/ to select the desired memory slot.
EN-5
/ to select 12 or
/
/
/ .
/ .
.