Vision TECHCONNECT tc2-ctl2 Manual Del Usuario página 8

2. INPUT FUNCTION BUTTON PROGRAMMING
The INPUT BUTTONS ( 4 / 5 / 6 ) can learn four codes each and send them one after the other, or
two at a time.
Before you start programming you should select "Single Command" or "Dual Command" using the
switch on the rear.
a) SINGLE COMMAND
Empty memory positions will be skipped. It will cycle sequentially through the codes you have
programmed into it.
Example 1: If it has been taught four codes
b) DUAL COMMAND
The first two codes are for the display device, and the second two codes are for the amplifier.
This is because the Control
Press 1: Broadcasts code 1 first, then code 3 a second later.
Press 2: Broadcasts code 2 first, then code 4 a second later.... etc
To program these buttons follow the same steps as for the POWER BUTTONS. The LED on the front
panel will cycle through RED > ORANGE > GREEN > ORANGE >, each representing the four codes
each button can learn.
3. VOLUME FUNCTION BUTTON PROGRAMMING
The VOLUME BUTTONS ( 7 / 8 / 9 ) can only learn one code each. They are preset to send out the
code repeatedly if the button is held down. The position of the Single/Dual Command switch has no
affect on these buttons.
The process for programming these buttons is different to the other buttons:
a) Press and release LEARN button. The RED LED on the REAR panel will light and stay on indicating
that the device is in "Learn Mode".
b) Press and release FUNCTION button you want to assign the code to on the front panel. The RED
LED on the REAR panel will flash once then it will stay on.
c) Aim the original remote control at the IR RECEIVER on the rear of the module and press and
hold the function button on the remote control. Release only after the GREEN LED on the REAR
has flashed three times. The device will automatically switch to "Normal Mode".
If the red light flashes it means the code has not been learnt successfully. Repeat steps b and c again.
4. DELETING CODES
If you want delete a code that you've programmed to a button follow these steps:
a) Press and release learn button (rear red light comes on and stays on)
b) Press and hold the appropriate FUNCTION button on front panel until the front LED is the colour
representing the code you wish to delete then release.
c) Press and hold buttons 7 and 9 until the front LED turns off.
6
The code has been deleted and the Control
Press 1: Input 1
Press 2: Input 2
Press 3: Input 3
Press 4: Input 4
Press 5: Input 1... etc
broadcasts codes in the following order:
2
reverts back to "normal mode".
2
Example 2: If it has been taught two codes
Press 1: Input 1
Press 2: Input 2
Press 3: Input 1... etc