Accessories Included; Troubleshooting - Vision TECHCONNECT tc2-ctl2 Manual Del Usuario

SPECIFICATIONS
• Power Consumption:
Static: <= 5uA / Sending: <= 20mA / Copying: <= 10mA
• Dimensions: 71 x 42 x 31mm
• Weight: 63 grams
• Colour: White
Note: Because we are committed to improving our products,
the details above may change without prior warning.

TROUBLESHOOTING

If your system is not operating properly, please refer to the following information. If the problem persists,
disconnect from power and contact your AV reseller immediately.
Problem
No LED when front buttons pressed
Module fails to learn the code
Module learns code but doesn't
control the projector
WARRANTY
This product comes with a 2-year return to base warranty, effective from the date of purchase. This
warranty applies only to the original purchaser and is not transferable. For the avoidance of doubt, this
will be taken from the information held by the appointed national distributor at the point of sale. If the
product is DOA (dead on arrival), you have 21 days from purchase date to notify the national distributor
via your AV reseller. The liability of the manufacturer and its appointed service company is limited to
the cost of repair and/or replacement of the faulty unit under warranty, except for death or injury
(EU85/374/EEC). This warranty protects you against the following:
• Failure of any components.
• Damage when the product is first removed from its packaging if reported within 24 hours of purchase.
If you find you do have a problem with this product, you should contact the AV reseller you
purchased this product from. The original purchaser is responsible for shipment of the product to the
manufacturer's appointed service centre for repair. We will endeavour to return repaired units within
5 working days, however this may not always be possible, in which case it will be returned as soon as
practicably possible. In line with our WEEE commitments, the manufacturer endeavours to replace the
faulty parts of the product rather than replacing the whole unit. This warranty does not protect this
product against faults caused by abuse, misuse, incorrect installation, unstable or faulty power input,
10
which might be caused by ignoring the guidelines set out in this manual.

ACCESSORIES INCLUDED

26 x Interchangeable buttons
1 x Single-Gang Techconnect Backbox
1 x Single-Gang Techconnect Surround
1 x IR Blaster with 10m cable
2 x IR Blaster without cable
1 x 3V Lithium CR2450 Battery
Correction
• Replace battery
• Check mains power connection (if present)
• Make sure codes have been learnt
• Make sure the original remote is 30-50mm away from the receiver
on the rear of the module, and at 90 degrees.
• Make sure the original remote has fresh batteries.
• Hold down the button on the original remote for longer until after
the green LED lights on the Module.
• Re-program the buttons.
• Re-position the IR blaster.
• Check IR blaster cable to make sure it hasn't been damaged during
installation.