Vision TECHCONNECT tc2-ctl2 Manual Del Usuario página 11

A. Projector
1. Stuck on the IR receiver built in to the projector
2. Sitting near the IR receiver
3. Attached to a wall directly facing the IR receiver
Two additional IR emitters are included if you need to control other equipment such as amplifiers
or motorized projection screens. To use these you will need additional Techconnect minijack cables
2
available in 10, 15, or 20m lengths. Termination of these Techconnect minijack cables is as follows:
2
White: -
Red: +
Shield: unterminated
Multiple IR Blaster cables should be connected to the same IR OUTPUT phoenix connector on the
rear panel of the Control .
2
9