Instruction For Use; Fitting/Replacing The Battery; Select Start And Direction Of Rotation; Switching Lighting On Or Off - Wiha speedE Manual Del Usuario

INSTRUCTION FOR USE

<

Fitting/replacing the battery

Open the end cap by twisting in an anti-clockwise direction. To change the battery, remove the empty battery
screwdriver handle . Then insert the charged battery
the right position („-" in the end cap

Select start and direction of rotation

Twist the ring switch to start the automatic assisted screw-driving. The direction of drive is determined by the direction that the
ring switch is turned (clockwise/anti-clockwise).
If the ring switch is released, it automatically returns to its home position and the screwdriver stops rotating.
The speedE can then be used as a normal screwdriver.
Note: There is only one rotation speed, which provides a max. of 0.4 Nm to assist with screw fastening. The user can apply higher
fastening force manually if required. The user can combine activated drive and manual fastening.

Switching lighting on or off

You can activate the ring switch
electric motor.
Note: The light comes on for 5 seconds after you activate the ring switch.

Battery level indicator

If the light flashes, it indicates that the speedE battery is low (<20%). Electric assisted screw-driving will still work when the
charge level is at 20%. If the charge level continues to fall, only the light

Loading the batteries

Use the designated power supply unit to connect the charger to the power circuit. The charge level indicator will first flash red briefly,
then light up green. This tells you that the charger is ready for operation.
Info: The charge level indicator will light up red if the batteries are charging. It will change to green once the battery is charged.

Instructions for use

Only place the speedE on the screw when the electric assisted screw-driving is switched off. Rotating tools may slip if switched on.
into the screwdriver handle
). Replace the end cap on the speedE, turning it in a clockwise direction.
to turn on the light . Tap on the ring switch
. Ensure the battery pole terminals are in
briefly to illuminate without activating the
will work to indicate that the battery
EN
from the
is empty.
13