Connect An Rj-45 Lan Cable; Connect The Ethernet Cable - Cognex In-Sight Micro Serie Manual De Instrucciones

6. Connect the other end of the frame ground wire to frame ground.
CAUTION: The shield ground connections of the RS-232 port, LAN port, PoE
port, I/O port and Frame Ground terminal are internally connected. The
system grounding is designed to be at a zero ground potential; this zero
ground potential extends through the cable and to peripheral equipment (e.g.
a vision system, PLC, etc.). To ensure safe operating conditions, it is strongly
recommended that all ground connections are checked to ensure that a zero
ground potential is met.

Connect an RJ-45 LAN Cable

To connect the vision system to an Ethernet network, plug a LAN cable (RJ-45
connector) into the I/O module's LAN port and connect the other end of the cable to a
switch/router or PC, as applicable.

Connect the Ethernet Cable

CAUTION:
All cable connectors are "keyed" to fit the connectors on the vision
l
system; do not force the connections or damage may occur.
The I/O module's PoE port provides power and Ethernet connectivity
l
to the In-Sight Micro vision system. Connecting third-party devices to
the I/O module's PoE port could damage the I/O module.
1. Connect the Ethernet cable's M12 connector to the vision system's PoE
connector.
2. Connect the Ethernet cable's RJ-45 connector to the I/O module's PoE port.
3. Restore power to the I/O module's 24VDC power supply and turn it on if
8