winncare WINN’SAVE VCBTFT005-00 Manual De Instrucciones página 13

INSTRUCTIONS
Magnetic closing
Put the stainless steel tip through the eyelet hole in the fabric strap. Insert the strap eyelet intended to close the restraining device. Close by
clicking the button on the tip. The magnetic key will open the device by removing the button.
Precautions: when installing a restraining device, check that the closing system is correctly locked.
To facilitate opening, release the pressure applied to the button.
Device for restraining or securing the patient's waist and/or pelvis to the wheelchair
Waist strap + pelvic strap – Magnetic closing – Ref.: VCBTFT005-10 / 20 / 30
Place the waist strap with its perineal part preadjusted by making sure that you are not obstructing the patient's breathing when you tighten
the waist strap.
With chest harness for restraint – Magnetic closing – Ref.: VCBTFT005-00
Place the chest strap with the perineal part then secure the front part of the harness first and then the rear part, making sure the fastening
point is in the middle.
Jacket + pelvic strap – Sliding buckle and closing – Ref.: VCNTFT008-10 / 20 / 30
Fig. 1 Fig. 2
T-shaped waist and pelvic restraint – Sliding buckle and closing – Ref.: VCNTFT012-10 / 20 / 30
Fig. 1 Fig. 2
Fig. 3 Fig. 4
Fig. 3 Fig. 4 Fig. 5
Install the jacket on the seat. (Fig.1)
Sit the patient down. Lift the perineal part strap and each
of the straps passing over the patient's shoulders to the
back of the arm/wheelchair. (Fig.2)
Adjust the length using the sliding buckle. (Fig.3)
Secure everything using the quick fasteners. (Fig.4)
Install the device on the arm/wheelchair. (Fig. 1)
Place the waist strap around the patient's waist and cross
the straps behind him/her level with his/her lumbar region.
(Fig. 2, 3)
Attach the straps on each side by adjusting the tightness –
without compressing the patient's waist. (Fig. 4)
Fasten the end of the perineal part to the straps behind the
arm/wheelchair. (Fig.5)
11