Technical Specifications - HQ-Power LEDA03 Manual Del Usuario

• The LEDA03 receives power and signal from the controller (LEDA03C,
not incl.). Refer to the illustration on page 2 of this manual.
• Always connect the LED-lamp to the OUT-1 port of the splitter and the
linking cable from OUT-2 of one splitter to IN of the next. Only the last
splitter in the chain must have a LED-lamp connected to OUT-2.
• Connect the IN-port of the first splitter in the chain to the OUTPUT port
of the controller (LEDA03C, not incl.).
Notes:
• When a single LEDA03 is used, connect it straight to the OUTPUT port
of the controller.
• The linking cables are straight cables.
• Connect max. 12 LEDA03s to a controller.
6.

Technical specifications

power supply
power/data input
power consumption
light source
beam angle
dimensions
weight
Use this device with original accessories only. Velleman nv cannot
be held responsible in the event of damage or injury resulted from
(incorrect) use of this device. For more info concerning this product,
please visit our website www.hqpower.eu. The information in this
manual is subject to change without prior notice.
© COPYRIGHT NOTICE
This manual is copyrighted. The copyright to this manual is owned
by Velleman nv. All worldwide rights reserved. No part of this manual may
be copied, reproduced, translated or reduced to any electronic medium or
otherwise without the prior written consent of the copyright holder.
18.05.2010
LEDA03
48VDC / 350mA (via optional controller LEDA03C)
RJ45
3W
3 x 1W
45°
Ø50 x 71mm
0.2kg
5
Rev. 01
©Velleman nv