Functional Description - Makita M9204 Manual De Instrucciones

FUNCTIONAL
DESCRIPTION
CAUTION:
Always be sure that the tool is
switched off and unplugged before adjusting or
checking function on the tool.
Switch action
CAUTION:
Before plugging in the tool, always be sure that the tool is switched off.
1
Fig.1
► 1. Switch
To start the tool, press the "I (ON)" side of the switch. To
stop the tool, press the "O (OFF)" side of the switch.
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and unplugged before carrying out
any work on the tool.
Installing or removing abrasive disc
Fig.2
To install the abrasive disc, first remove all dirt or for-
eign matter from the pad. Then peel off the backing
paper from the abrasive disc and attach the abrasive
disc to the pad.
Be careful to align the holes in the abrasive disc with
those in the pad.
CAUTION:
If you peel off the abrasive disc
from the pad, its adhesion will become poor.
Never attempt to stick it onto the pad for further
use.
Installing dust bag
Fig.3
► 1. Dust bag
Install the dust bag on the tool so that the logo on the
dust bag will be upright (not upside down).
Emptying dust bag
1
Fig.4
► 1. Dust nozzle 2. Dust bag
When the dust bag is about half full, switch off and
unplug the tool. Remove the dust bag from the tool.
Then remove the dust nozzle from the dust bag
after unlocking the dust nozzle by turning it slightly
counterclockwise.
Empty the dust bag by tapping it lightly.
After emptying the dust bag, install the dust nozzle on
the dust bag. Turn the dust nozzle slightly clockwise to
lock it in place. Then install the dust bag on the tool as
described in "Installing dust bag".
OPERATION
Sanding operation
CAUTION:
Never switch on the tool when it
is in contact with the workpiece, it may cause an
injury to operator.
4 ENGLISH
1
2