Tabla de contenido
Idiomas disponibles
Idiomas disponibles
NOTE:
Depending on the conditions of use and the
•
ambient temperature, the indication may differ
slightly from the actual capacity.
Switch action
008876
CAUTION:
Before inserting the battery cartridge into the tool,
•
always check to see that the switch trigger actuates
properly and returns to the "OFF" position when
released.
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
Lighting up the front lamp
1
008889
CAUTION:
Do not look in the light or see the source of light
•
directly.
Pull the switch trigger to light up the lamp. The lamp
keeps on lighting while the switch trigger is being pulled.
The lamp goes out 10 -15 seconds after releasing the
trigger.
NOTE:
Use a dry cloth to wipe the dirt off the lens of lamp.
•
Be careful not to scratch the lens of lamp, or it may
lower the illumination.
1. Switch trigger
1
1. Lamp
Reversing switch action
1
A
008877
This tool has a reversing switch to change the direction of
rotation. Depress the reversing switch lever from the A
side for clockwise rotation or from the B side for
counterclockwise rotation.
When the reversing switch lever is in the neutral position,
the switch trigger cannot be pulled.
CAUTION:
Always check the direction of rotation before
•
operation.
Use the reversing switch only after the tool comes
•
to a complete stop. Changing the direction of
rotation before the tool stops may damage the tool.
When not operating the tool, always set the reversing
switch lever to the neutral position.
Depth adjustment
1
A
B
008878
The depth can be adjusted by turning the locator. Turn it
in "B" direction for less depth and in "A" direction for more
depth. One full turn of the locator equals 1.5 mm
(1/16")change in depth.
Adjust the locator so that the distance between the tip of
the locator and the screw head is approximately 1 mm
(0.04") as shown in the figures. Drive a trial screw into
your material or a piece of duplicate material. If the depth
is still not suitable for the screw, continue adjusting until
you obtain the proper depth setting.
6
1. Reversing switch
lever
B
1. Locator
Tabla de contenido
