Parts Identification - Hema 80.06.0018 Manual De Instrucciones

PARTS IDENTIFICATION

Front view
1. Take-up lever
2. Upper thread tension dial
3. Pattern selection dial
4. Thread cuter
5. Light
6. Needle clamp screw
7. Bottom bobbin
8. Drawer
9. Hand wheel
10. Reverse button
11. Power & speed switch
Back view
1. Bobbin winder pin
2. Bobbin winder stop
3. Foot pedal input
4. Bobbin winder tension disk
5. Presser foot lifter
6. Presser foot
7. DC input
8. Battery compartment
9. Spindle
USING THE FOOT PEDAL (A) AND ADAPTOR (B)
1. Connect the foot pedal by inserting the jack into the foot pedal input socket. Then you can use the foot
pedal to turn on the machine instead of using the hand switch (Power & speed switch).
2. Connect the adaptor's jack to the DC input socket on the back of the machine, and connect the plug to the
main power supply.
Caution:

Make sure the foot pedal is unplugged from the machine when you
are not using it, so the sewing machine won't accidentally start up.

The foot pedal cannot be used together with the power & speed
switch. Make sure the switch is placed at the position "OFF".

There is no speed selection when using foot pedal to control the
machine.
INSTALLING THE BATTERIES
1. Make sure the "Power & speed switch" is on the position "OFF".
2. Turn the sewing machine over on a flat surface and remove the battery compartment cover.
3. Insert 4xAA batteries (LR6 or recharchable HR6) nto the compartment and replace the battery cover.
Caution:

To prevent the accidental start-up of the sewing machine, always make sure that the "Power & speed
switch" is on the position "OFF" when inserting or removing the batteries.

When using the adapter, remember to remove all batteries from the machine.
- 29 -