Idiomas disponibles
Idiomas disponibles
SF 0440
ASSEMBLY
1. Remove all parts from the carton:
• Motor assembly, including:
- Grill nut and blade knob
• Grill set, front and rear
• Fan blade
• Pole assembly
• Base
• Component pack, including:
- Bolts
- Wing nuts
- Bolt plate
- Cover
2. Assemble fan head
• Remove the grill nut and blade knob
from the motor assembly, note that
the blade knob is reverse threaded.
Turn clockwise to remove from the
motor shaft.
• Place the rear grill over the motor
shaft and onto the motor. Assembly
nothing that the handle should be
positioned toward the top of the
fan. The small plastic pin of the
motor assembly should be aligned
with the hole in the rear grill.
Reattach the grill nut, turning
clockwise to secure the rear grill to
the motor assembly.
• Align the motor shaft with the "D" shaped hole of the fan blade. Fully insert the motor shaft into the fan
blade, then secure with the blade knob, turning counter-clockwise. Do
not overtighten.
• Place the front grille facing the rear and joins with the locking ring.
Tighten the screw ring so that the grid is firmly united.
3. Base assembly
1. Forms a cross with the base and insert the tube through the center of
the cross and secure with the nut.
2. Lengthen the tube and join with the motor body. Tighten the screw
to secure the union.
4. Final assembly
• Twist the thumb screw at the bottom of the motor assembly counter-
clockwise until no threaded portion is visible within.
• Place the chrome end of the pole assembly within the hole at the
bottom of the motor assembly and fully insert. If the pole will not fully
insert, the thumb screw must be further loosened. Twist the thumb
screw clockwise to tighten the motor assembly to the pole and fan
assembly is now complete.
OPERATION
• Place the assembled fan on a flat, level, firm and dry surface.
• Plug the power cord into a polarized 230 volt AC wall outlet.
8
