cecotec HidroBoost 1600 Car&Bike Manual De Instrucciones página 27

2. Initial high-pressure rinse
Spray the cleaning surface with water to clear off any dirt or grime that may have collected
on the surface. Before triggering the gun, adjust the pulverizing nozzle to a wide stream and
slowly adjust it to the desired stream. This will avoid applying too much concentrated spray to
the surface which could cause damage.
3. Soap application
The soap and water percentages should be, approximately: 5.4 % soap, 94.6 % water (1 to 19).
WARNING:
• Use only soaps designed for pressure washers.
• Test soap in an inconspicuous area before use.
1. Unscrew the soap bottle tap and fill the applicator with soap.
2. Screw the accessory tap back again.
3. Remove the lance from the gun.
4. Attach the soap bottle to the gun. (See Figure 3).
5. Apply soap so it thoroughly covers the cleaning surface. Apply from bottom to top to
prevent soap from sliding down and streaking.
6. Allow soap to remain on the surface for a few minutes. Meanwhile, use a brush to
lightly scrub heavily-soiled areas. Never allow soap to dry on the cleaning surface.
7. Remove the soap bottle from the gun and replace it with the lance, or remove the
accessory from the end of the lance.
8. Rinse soap from surface.
NOTE: Rinse the soap bottle with clear water after each use.
4. Final rinse
Start the final rinse at the bottom and work upward. Make sure the surface is thoroughly
rinsed and that al dirt is removed.
5. Shut down
• Make sure all soap is flushed from the system.
• Turn the motor off.
HIDROBOOST 1600 CAR&BIKE
ENGLISH
Fig. 3
27