cecotec Conga 1590 Active Manual De Instrucciones página 28

• a. Plug one of the adapter ends into the robot's charging socket and the
other to the power supply. (Fig. a)
• b. While the charging base is connected to the power supply, press
the remote control for the robot to automatically return to the charging base. (Fig. b).
Note: if the robot's battery is low during operation, it will automatically return to the charging
base before running out.
3. Battery's service life
In order to lengthen the battery's service life:
• Allow the robot to charge for 5 hours during the first charge.
• Charge the robot as soon as possible when the battery is low.
• If the robot is not going to be used for a long time: fully charge the battery, switch the
robot off and store it in a cool and dry place.
• If the robot has been stored for a long time, allow it to charge for 5 hours before
operating it again.
REMOTE CONTROL
ON/OFF/STANDBY/SLEEP
1. ON/OFF
• Make sure the robot's power switch is ON.
• During standby mode, press
robot up.
• During sleeping status, press
again to start cleaning.
2. Standby
During this status, the robot is switched on and waiting for user operation.
• During operation, press
3. Sleep
During sleep status, press
• During standby mode, press
• During standby mode, the robot will enter sleep mode after 10 minutes of no
operation.
A
on the robot or on the remote control to start the
once to switch the robot to standby mode and then
to stop and switch the robot to standby mode.
on the robot or on the remote control to start the robot up.
on the robot for 5 seconds to enter sleep mode.
ENGLISH
on
B
29