Beper BC.001 Manual De Instrucciones página 11

EN
Espresso machine Use instructions
COMPONENTS
1. Water tank cover
2. Water tank handle
3. Water tank
4. Power indicator
5. Ready indicator
6. Knob
7. Steam wand
8. Froth device
9. ON/OFF switch
10. Coffee spoon
11. Drip tray
12. Drip plate
13. Funnel handle
14. Steel mesh
15. Steam button
Before the first use
To ensure the first cup of coffee tastes excellent, you should rinse the coffee maker with warm water
as follows:
1. Pour water into water tank, the water level should not exceed the "MAX" mark in the tank. Then
replace the water tank cover.
Note: the appliance is supplied with a detachable tank for easy cleaning, you can fill the tank with
water firstly, and then put the tank into the appliance.
2. Set steel mesh into metal funnel (no coffee in steel mesh). make sure the tube on the funnel ali-
gns with groove in the appliance, then insert the funnel into the appliance as indicating of "INSERT"
mark, and you can fix them into coffee maker firmly through turn it anticlockwise until it is fully locked.
3. Place an espresso cup (yourself cup) on removable drip plate. Make sure the knob is on the po-
sition which is the" "position.
Note: the appliance is not equipped with jug, please use yourself jug or coffee cup.
4. Connect to power source, press the ON/OFF switch. The power indicator (red) will be illuminated.
5. Turn the knob to the " " position, the pump will pump water, when there is water flowing out
and close the pump by turning knob again to the " " position, make sure the steam button is on
the higher position which is the " " position and waiting for a moment, the appliance begins to be
pre-heated until the ready indicator (blue) is illuminated, it shows the pre-heating is finish. Turn the
knob to the " " position again, and water will flow out.
6. After about one minute, turn the knob to the " " position to stop brewing, you can pour the water
in each container out then clean them thoroughly, now you can start brewing.
Pre-heating
To make a cup of good hot Espresso coffee, we recommend you preheating the appliance before
making coffee, including the funnel, filter and cup, so that the coffee flavour can not be influenced
by the cold parts.
1. Remove the detachable tank and open the tank cover to fill it with desired water, the water level
should not exceed the "MAX" mark in the tank. Then place the tank into the appliance properly.
11