EQ: graphic adjustment of the equalization curve in 14 frequency bands (80, 120, 190, 290, 440, 670,
6.-
1,000, 1,600, 2,400, 3,600, 5,600, 8,600, 13,000 and 20,000 Hz.).
Press the EQ button to start the equalization and the display will show the equalization curve. Next, use
the V- (a) and V+ (d) buttons to select the frequency to be equalized and the AN+ (w) and AN- (s)
buttons to adjust the gain for the selected frequency.
Finally, press the EQ button again to save the configuration.
FOCUS: adjustment of the distance from the acoustic centre.
7.-
Press the + and - buttons to select a value between -99% and +99% (except the range from -5 to
+5%).
BASS: bass frequency enhancement/attenuation.
8.-
The values of this parameter vary between 0 dB and +6 dB in increments of 2 dB.
TREBLE: treble frequency enhancement/attenuation.
9.-
The values of this parameter vary between 0 dB and +6 dB in increments of 2 dB.
10.- D9 connector for connection to the sound column.
11.- Information screen and IR receiver for the remote control.
CONNECTION
- These columns allow you to directly connect an output of a mixer or line-level audio source to the SIGNAL
INPUT of the column or to directly connect the speaker output of a PA amplifier to the 100V SIGNAL IN
terminals of the column.
- You can interconnect several columns using any of these 2 inputs. In the first case, you must connect
SIGNAL OUTPUT in the first column to the SIGNAL INPUT in the next column. If you want to use a 100 V
line amplifier, connect all columns in parallel, i.e. connect all positive poles to the positive terminal of the
amplifier and the negative ones to the negative terminal.
- Plug in the power supply and activate the power switch.
- Switch on the sound column with the remote control and start the configuration without switching on the
sound source.
- Make the sensitivity adjustment according to your source and switch on the mixer/amplifier.
- Complete the configuration of the parameters in the column.
- 5 -
EN