FONESTAR FCS-10101D Manual De Instrucciones página 4

EN
COLUMN PARAMETER SETTING WITH MOD. FCS-RC01
To configure the display parameters, you will need the
control knob and the FCS-RC01 remote control.
- Connect a cable with DB9 connectors between the
control knob and the CONTROL port on the
column.
- Configure all the parameters you would like in order
to ensure an optimal configuration. These
parameters will vary depending on the acoustic
conditions presented by the venue, the audience
and the intended use (voice or music).
- Below, we explain how to operate the remote
control.
NOTE: if, while configuring, 30 seconds pass without
any button on the remote control being pressed, the
display will go into standby mode and the completed
settings will be stored in the internal memory of the
column.
q: Power/Standby of the sound column.
1.-
2.- Activates/Mutes the audio output.
V-, V+: volume controls. The values of this parameter vary between 0 and 32 in increments of 1.
3.-
S: line input sensitivity adjustment.
4.-
Pressing the display once will show the current value of this parameter. To change the sensitivity value,
press and hold this button. The values of this parameter are: 0 dB, -6 dB or -10 dB.
AN+, AN-: adjustment of the inclination of the sound beam.
5.-
Press the AN+ button to increase the angle and AN- to decrease it. The values of this parameter vary
between +45º and -45º in increments of 1º.
- 4 -