Phonic POWERPOD 2000R Manual De Usuario página 9

29
28
Master Section
28. EFX to Monitor Control
This controls the level of the processed signal from the
built-in effect processor that is sent to the Monitor mix.
29. EFX to Main Control
This controls the level of the processed signal from the
built-in effect processor that is sent to the Main 1/2 mix.
30. Graphic Equalizers
These graphic equalizers allow you to adjust the frequency
response of a signal, with a maximum of ±12 dB of signal
boost or cut for each of the frequencies. The Powepods
2000R features 7-band graphic equalizers for each the
Main and Monitor mixes. The uppermost equalizer is for
alteration of the Main signal, where the lower equalizer is
for the Monitor signal (or Main 2, depending on the AMP
MODE).
31. Monitor Level Control
This rotary control allows the user to adjust the final signal
level sent to all Monitor outputs.
32. Main Level Control
This rotary control allows the user to
adjust the final signal level sent to
the Main and Speaker outputs.
33. Mute 1-7
This button will activate a mute
of channels 1 through 7. This
essentially enabling you to use
the channel 8 RCA connectors to
provide music between sets without
inadvertently sending audio through
other channels.
34. Speaker Enhance
Using this switch will enable the
user to give both the high and low
frequencies of their main mix a
little boost to improve the overall
robustness of the audio. There is no
guarantee your sound will improve
with the speaker enhancement activated, so it's probably
a good idea to audition the mixer's sound with this switch
on and off, and decide which is better for your purposes.
POWERPOD 2000R
35.
This switch controls the activity of the built-in power
amp, enabling the user to alternate between the different
signals which can be processed by the built-in power
amp and routed to the speaker outputs on the rear of
the device. It allows you to select from: Main / Monitor –
taking the monitor and main signals and directing them
to the appropriate speaker outputs – or Main 1 / Main 2 –
using the Main signal to feed the speaker outputs.
36.
These
accurate indications of when
audio levels of the Main and
Monitor outputs reach certain
levels. The 0 dB indicator
illuminates
equal to an output level of +4
dBu. It is suggested that users
set the various level controls so
that it sits steadily between 0
and +6. This will make full use
of audio while still maintaining
31
fantastic clarity. The Powerpod
2000R features two 5-segment
LED display, one for each the
Main and Monitor signals.
32
37.
These LED indicators illuminate when the power
amplifier's built-in limiters are activated, which effectively
reduce signal levels when they reach high levels that
could prove to damage sound quality.
33
38.
This LED indicator illuminates when power of your
Powerpod mixer is activated.
34
39.
This button will activate +48V of phantom power on XLR
microphone inputs 1 through 8. This is perfect for use with
condenser microphones and other devices that require
phantom power. Please ensure your microphones and
other input sources are compatible with phantom power
before activating.
30
Amp Select Switch
Level Meter 38
level meters give
37
36
is approximately
35
39
Limiters
Power Indicator
Phantom Power Button
5