Flotec OMNIA 80/5 Manual De Uso Y Manutención página 7

GB
(*) These data refer to Fig. 1. Measurements are expressed in millimetres.
The minimum priming level corresponds to a condition in which the delivery mouth is completely submersed.
(See Fig. 1 - Reference A)
CHAP. 3 INSTALLATION
Please use handlebar to remove or lift pump up.
Please use a non-return valve in case pump is connected to fixed installation with rigid piping; this will avoid liquid
circulating when pump has been turned off; use of a pipe fitting will allow easy disconnection of pump for maintenance.
Dimensions of drain well must allow max. 30 on/off cycles/hour. ( See USE AND HIS LIMITATIONS )
Please use flexible pipe connected to pump by means of plastic fitting in case of temporary use of pump.
Use a rope to immerse pump and fasten it to pump's handlebar.
OMNIA® aut is equipped with a pre-rated float switch ( See Pict. 1 ); please increase or decrease the free piece of float
switch cable by making it sliding through the proper seat on the handlebar, when modifying the rating of float switch.
Pumps used besides garden ponds or similar places may have special requirements.
CHAP. 4 ELECTRIC CONNECTION
The supply cord is equipped with double ground contact, plug so grounding is done when plugging in.
Overload protection
OMNIA® range pumps have a built-in thermal overload with automatic reset.
Further protections are not required.
CHAP. 5 MAINTENANCE AND TROUBLE SHOOTING
When installing, please ensure pump is disconnected from electric current
network. Pumps in this series are not suitable for use in a swimming pool
DANGER
and the relevant cleaning and servicing operations.
Electric shock risk
This appliance can be used by children aged 8 years or over and by persons with
limited physical, sensory or intellectual capabilities, or with limited experience
and knowledge, provided that they are supervised or have been instructed in
DANGER
the safe use of the appliance and are aware of the dangers involved. Children
must not be allowed to play with the appliance. Cleaning and user maintenance
must not be carried out by children unless they are supervised
Pollution of the liquid could occur due to the leakage of lubricants
WARNING
REMARK
REMARK
REMARK
DANGER
Electric shock risk
DANGER
Electric shock risk
DANGER
Electric shock risk
DANGER
Electric shock risk
Make sure that float switch turns off pump, when at min.
level of liquid.
Make sure no obstacles stand in the way of float switch,
during up/down swinging.
Ensure tension and frequency of pump (read motor plate)
and supply network are same.
Installer must make sure that electric current network has
ground wire conforming to current laws.
Make sure that electric current network is provided with a
high-sensitivity circuit-breaker
D
=30 mA (DIN VDE 0100T739)
Before doing any operation, make sure pump is
disconnected from electric current network.
Power cord must be replaced by manufacturer or
by Customer service, using special tools.
5