Inserting Battery - LaserLiner ClimaHome-Check Manual De Instrucciones

1

Inserting battery

Open the battery compartment and insert
battery according to the symbols. Be sure
to pay attention to polarity.
The device has been optimised for use in fixed measuring
!
locations. Please wait 10 minutes after switching to a measuring
location with a significantly different level of humidity.
2
°C / °F
To set the required temperature unit, press and hold the „°C/°F"
button until the corresponding symbol appears on the display.
3
MAX / MIN
To determine the maximum or minimum temperature during a
measurement, press and hold the „MAX / MIN" button until either
„MAX" or „MIN" appear on the display. The normal measuring
mode is set when no function flashes on the display.
4
CLEAR
By pressing the CLEAR button, the MAX and MIN values are reset.
Information on maintenance and care
Clean all components with a damp cloth and do not use cleaning
agents, scouring agents and solvents. Store the device in a clean and
dry place.
Technical data
Ambient temperature
Measurement range / Precision 0 °C ... 50 °C / ±1 °C
Relative humidity
Measurement range / Precision
Operating conditions
Storage conditions
Power supply
Dimensions (W x H x D)
Weight (incl. battery)
EU directives and disposal
This device complies with all necessary standards for the
free movement of goods within the EU.
This product is an electric device and must be collected
separately for disposal according to the European Directive
on waste electrical and electronic equipment.
Further safety and supplementary notices at:
http://laserliner.com/info?an=cliche
(Subject to technical changes without notice. 09.17)
ClimaHome-Check
20%rH ... 99%rH / ± 5%rH
(25%rH...85%rH, @152 m above
sea level)
0 ... 50°C, 99%rH
0 ... 50°C, 80%rH
1 x 1.5V alkaline battery
(type AAA)
66 x 57 x 17 mm
47 g
05
EN