Auto Off Function; Insertion Of Batteries - LaserLiner ClampMeter XP Manual De Instrucciones

Maximum limit values
Function
Current AC/DC
Voltage AC/DC
Frequency, continuity, resistance,
diode test, continuity, capacitance
Temperature (°C/°F)

AUTO OFF function

In order to preserve the batteries, the meter switches off automatically if it is left idle for 30 minutes.
Deactivation of AUTO-OFF function
1.
Rotary switch
set to „OFF"
The " " symbol is not shown when auto power-off is deactivated. Auto power-off is reset by switching
off the measuring device.

Insertion of batteries

1
Open the battery compartment (10) and insert
batteries according to the symbols. Be sure to pay
attention to polarity.
2.
Press and hold MODE button while at the same
time turning the rotary switch to the required position
ClampMeter XP ClampMeter XP
Maximum limit values
1000A AC/DC
1000V AC/DC
600V AC/DC
600V AC/DC
Attaching the test prods
2
To avoid the risk of injury, the test prods must
always be kept in the holder at the rear of the
device with the protective caps fitted when not
in use and during transportation.
!
TO AVOID ELECTRICAL SHOCK,
REMOVE ALL TEST LEADS
BEFORE OPENING THE CASE
OR BATTERY DOOR. DO NOT
OPERATE WITH BATTERY
DOOR OPEN.
ClampMeter XP
A quality product from
Donnerfeld 2, 59757 Arnsberg
Germany, Tel.: +49 2932 638-300
Fax -333, www.laserliner.com
3.
„APO d" appears
on the LC display
WARNING
GmbH & Co. KG
EN
19