Installing The Electric T-Junction - Franke AQRM688 Instrucciones De Montaje

9.3 Align the water volume regulator in such a way that the screw plug (d) and the
operating element (e) are freely accessible. If necessary, loosen the flush connector
for this purpose.
9.4 For fittings with optional thermal disinfection:
Lay the electrical lines (siehe Kapitel 11. to
9.5 Open the water volume regulator with a hollow hexagon wrench.
x: closed
y: open
9.6 Flush the pipes in compliance with DIN 1988.
9.7 Check the connections for leaks.
9.8 Place the protective cover on the cabinet for the duration of the construction work.

10. Installing the Electric T-junction

☞
Important!
The components of the electric T-junction must be installed only when they are in a
dead condition.
☞
For recommended system lines siehe
When using other cables for the system line, note the different colour coding. The
outer diameter must not exceed 7.5 mm.
10.1 Strip the shielding (a) off from the system lines (approx. 40 mm).
10.2 Place the union nut (c) on the system line (b) up to the stop.
☞
The cable cores are marked with numbers 1 through 4.
10.3 Latch the cable cores (d) into the cable core guides (e) according to their colours.
A: Union nut
B: FAR-Order-No. 84-032-12.468
FAR-Order-No. 84-032-12.534
FAR-Order-No. 84-032-12.563
FAR-Order-No. 84-032-12.720
10.4 Cut off the protruding ends of the cable core so that they are flush, i. e. so that they
do not protrude.
10.5 Place the union nut (c) on the electric T-junction (f) and tighten with the required
torque (1.2 Nm).
Important!
Ensure correct polarity.
Each core cable colour must be in the same cable core guide on both union nuts.
☞
When the union nut is being tightened, the electrical contact and the pull-relief are
automatically established.
Special seals provide protection against dust and water.
6
Kapitel 13).
Kapitel 12., Accessories.
1
2
3
4
A B
brown red
white white
blue blue
black black