Franke FMPL 606 BK B Manual De Uso página 8

Controls
Button
Function
A Turns the Motor off.
Enables / Disables Keyboard Lock mode if pressed and
held for 5 seconds.
B Activates speed one.
Pressing and holding the button for 5 seconds enables the
remote control.
Pressing and holding the button for 5 seconds disables the
remote control.
C Activates speed two.
D Activates speed three.
E Activates Intensive speed. This speed is timed to run for 6
minutes. At the end of this time the system will automatically
return to the speed set before.
It is disabled by pressing the Button or turning the Motor off.
F Activates Delay mode, with automatic shutdown of the Motor,
the Fans and the Lighting with a 15' delay.
It is disabled by pressing the button or turning the motor off.
Press and hold the button for approximately 5 seconds,
with all the loads turned off (Motor and Lights), to turn the
Activated Charcoal Filter alarm on.
To turn it off, press and hold the button again for 5 seconds.
G Press briefly to turn the lighting system on and off at
maximum intensity.
Press and hold the button for 2 seconds to turn the Courtesy
Lights On.
H When the filters alarm is triggered, the alarm can be reset by
pressing and holding this button for approximately 5 seconds,
all leds flash twice. These indications are only visible when
the motor is turned off.
Lighting
Warning: This appliance is fitted with a white LED
lamp classed as 1M according to EN 60825-1: 1994
+ A1:2002 + A2:2001 standards; maximum optical
power emitted @439nm: 7µW. Do not look directly
at the light through optical devices (binoculars, mag-
nifying glasses...).
• For replacement contact technical support ("To
purchase contact technical support").
8
Led
The Leds indicating the Speed of the motor turn off.
All the Leds light up in cycle.
All Leds flash twice.
All Leds flash once.
The Leds indicating Speed two and Motor Off turn on.
The Leds indicating Speed three and Motor Off turn on.
Flashes once a second.
The Delay Led lights up.
All Leds flash twice.
All Leds flash once.
The Lighting Led lights up.
When the procedure terminates, the indication shown
previously turns off:
C+H Flashing
Indicates the need to wash the metal grease filters. The
alarm is triggered after the Hood has been in operation
for 100 working hours.
D+H Flashing
Indicates the need to change the activated charcoal
filters, and also to wash the metal grease filters. The
alarm is triggered after the Hood has been in operation
for 200 working hours.