Performing Code Settings (When Encryption Function Is Off) - Toa WM-D5300 Serie Manual De Instrucciones

[switching the encryption function from On to OFF]
step 1. With the battery cover removed, switch ON the transmitter power switch
and confirm that the Encryption indicator is lit.
step 2. Switch OFF the power switch.
step 3. Switch ON the transmitter power switch while holding down the
Encryption setting switch.
note
Do not switch OFF the transmitter power switch during setting.
step 4. Confirm that the Encryption indicator has extinguished, then release the
Encryption setting switch.
The encryption setting switches to OFF.

8.3. Performing Code settings (When encryption Function is OFF)

8.3.1. Code setting summary
By presetting the specified code between the wireless transmitter and receiver, audio is only output
when a digital signal received from the wireless transmitter has the same ID code as the receiver.
Even if another signal is received from an adjacent area, if the code does not match, audio is not
output.
Ten varieties of code can be selected ([0] – [9]) for appropriate use, depending on circumstances.
8.3.2. Code settings
Code is factory-preset to "0."
note
Switch OFF the transmitter power switch when performing
settings. If the power switch is left ON, the codes will remain
unaffected even if the settings are manually changed.
step 1. After removing the battery cover, switch ON the
transmitter power switch.
step 2. Confirm that the Encryption indicator is unlit.
If it is lit, switch encryption from ON to OFF, referring to
p. 13, "Switching the Encryption function from OFF to
ON."
step 3. Switch OFF the power.
step 4. Using the supplied screwdriver, set the code setting
switch to the desired code number.
step 5. Replace the battery cover, as it was before.
This puts the code into the set state.
step 6. Set the same code number for the receiver, as well.
For the setting method, see the instruction manual
enclosed with the receiver.
14
Lit
Unlit
Unit
2
1
4
Screwdriver
(accesory)