When Operating On Rechargeable Battery; How To Charge - Toa WM-5325 Manual De Instrucciones

Ocultar thumbs Ver también para WM-5325:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

7. WHEN OPERATING ON RECHARGEABLE BATTERY

CAUTION
Notes
• When operating on rechargeable batteries, the optional BC-5000 Battery Charger is required.
• For rechargeable batteries, be sure to use the optional WB-2000 battery. Do not use other batteries.

7.1. How to Charge

Step 1. Set the wireless transmitter's power switch to the
OFF position.
Note
Be sure to turn off the transmitter's power switch
when charging. Batteries cannot be correctly charged
if the power switch is ON.
Step 2. Place the WB-2000 rechargeable battery in the
wireless transmitter.
(Refer to p. 6 "Battery insertion.")
Step 3. Fully insert the wireless transmitter into the
transmitter receptacle of the BC-5000 Battery
Charger.
The BC-5000's charging indicator lights red and
charging begins.
Charging is completed in approximately 3 hours and
the BC-5000's full-charge indicator lights green.
Notes
• If the red charging indicator does not light even if the wireless transmitter has been inserted into the
charger, check to see if the transmitter has been correctly inserted.
• The wireless transmitter becomes warm after charging completion, however this is not a failure.
Note: For more information, please read the instruction manual enclosed with the BC-5000 Battery Charger.
7.2. Charging Timing
Please charge the equipment immediately when green LED light is off
and red light is on during use.
When the battery alarm lamp on the receiver is on, the battery level of
the transmitter is low as well.
The transmitter will not be able to operate within a few minutes.
Even though the battery remains enough, both green and red lights
might be on at the same time.
[Guidelines on the rechargeable battery operation time]
Continuous usage time: Approx. 13 hours
Notes
• When using the WB-2000 rechargeable battery for the first time or when using it after it has been stored for
a long period of time, be sure to charge it before use.
• The WB-2000 battery is designed to cycle through about 500 charges and discharges. When the transmitter
operation interval becomes extremely short after prolonged repeated use, change the battery with a new
one.
When charging, never insert rechargeable batteries other than the
specified WB-2000 battery in the wireless microphone (transmitter).
Charging any other than the WB-2000 battery may result in fire or
personal injury due to battery rupture.
1
Charging indicator (red)
Full-charge indicator (green)
Power switch
Note
Can be placed in either
backward looking or
forward looking
orientation.
3
Power/Battery lamps
7
Tabla de contenido
loading

Tabla de contenido