Performing Transmission Output Changeover Switch Settings - Toa WM-D5300 Serie Manual De Instrucciones

8.4. Performing transmission Output Changeover switch settings

Transmission can be set for either of two outputs: 'H' (10 mW) or 'L' (1 mW).
The switch is factory-preset to the 'H' position.
note
Be sure to turn the transmitter's power switch OFF before performing settings.
step 1. Confirm that the power switch is turned OFF, then
remove the battery cover.
step 2. Using the supplied screwdriver, set the changeover
switch to the desired transmission output.
Set the switch to the 'H' position when using the
transmitter in a wide area.
If the same bank and channel are used in close
proximity in adjacent locations, set the switch to the
'L' position to shorten the radio wave transmission
range for each location to minimize interference.
step 3. Securely replace the battery cover.
2
Screwdriver
(accesory)
Transmission output
changeover switch
1
15