Ecolab Versatronic Instrucciones De Servicio Breves página 95

Dispositivo de medición modular de varios canales
Ocultar thumbs Ver también para Versatronic:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

Device menu
Configuration
point
Ch. X Al2 limit
Ch. X Cal.timer y / n
Ch. X Calib. interv.
Rgl. X controller type
Rgl. X of action
Rgl. X monitoring y / n Inactive
Rgl. X monitoring time 0-9999 s
Rgl. X released y / n
Rgl. X add. Freig.eing. Binary inputs /
417102279 Rev. 2-08.2020
Selection/configuration
-99999 to 99999
Inactive
active
0-9999 days
* Out
* Two-point controller
* Three-point controller
** Coarse / fine controllers
Three-point step controller
Stet. Controller with positioner.
*Continuous controller
* = please select only the marked points!
Directly
(Controller switches on
exceeding of the target value a)
Inverse
(Controller switches falls below
the setpoint a)
active
Inactive
active
*IN1 Binary input 1
*IN2 Binary input 2
*IN3 Binary input 3
*IN13 Binary input 4
IN14 Binary input 5
IN15 Binary input 6
* = please select only the marked points!
44
Explanation
Alarm 2 limit value setting 0,0000
Activation Calibration
Determining the
calibration interval
The calibration interval is
the time after which a
Calibration reminder is
displayed.
After performing a
calibration, the Calibration
Reminder is deleted on
the display.
Choosing the controller
type
Choice of control direction Directly
Activation of the
dispensing monitoring
Set the monitoring time
If the specification is not
reached after this time, an
alarm is displayed.
The external enable
activation
(After activation of the
controller is only enabled if
the associated input a
closed contact is applied)
Assigning channels -
inputs
Channel 1: IN1
Channel 2: IN2
Channel 3: IN3
Channel 4: IN13 (pin 1 +
4)
Provision of an additional
enable input
The selected input is AND
linked to the input, which
is assigned by default to
the respective channel.
Example: At channel 1 IN2
is selected here:
Controller 1 is enabled
only when a closed
contact abuts IN 1 and IN.
2.
Default
Inactive
10 days
Two-point controller
Inactive
600 sec
Inactive
Channel 1: IN 1
Channel 2: IN 2
Channel 3: IN 3
Channel 4: IN 13
Tabla de contenido
loading

Este manual también es adecuado para:

255201

Tabla de contenido