Checking/Replacing Battery(Ies) Of Remote Control - Num'axes Canicom 800 Manual De Instrucciones

Programming the Booster button for the dog A or 1 (black collar):
- press the « A » or « 1 » button for approximately 5 seconds until the level of stimulations flashes
on the LCD screen
- press the « + » or « - » button to modify the level of stimulations
- press the « A » or « 1 » button to confirm the level selected
Renew the same procedure to program the Booster button for the dog B or the dogs 2, 3 and 4.
 « + » and « - » : control buttons
Use the +/- buttons for rapid adjustment of the stimulation level of the receiver collar.
15 levels are available for CANICOM 800.
18 levels are available for CANICOM 1500.
Level 1: very weak stimulations. Level 15 or 18: strong stimulations.
Always start with the lowest level of stimulation.
 Retro-lightning of the LCD screen
You can light the LCD screen for approximately 6 seconds by pressing briefly the On/Off switch
(approx. 1/2 second).

Checking/replacing battery(ies) of remote control


Performance (radio range) of the remote control may deteriorate as battery(ies) become(s) weak.
Be prepared to replace the battery(ies).
To check the condition of the battery(ies), turn "on" the CANICOM 800/CANICOM 1500 remote control and
look at the battery level indicator on the LCD screen. The symbols which appear indicate the following:
Remove the old batteries and replace them:
- 1 3-V Lithium CR2 battery for the CANICOM 800 remote control
- 2 LR06 alkaline batteries for the CANICOM 1500 remote control
Replace the battery(ies) as follows:
- On the back of the remote control, unscrew the screw and remove the battery cover (ref.
Diagram 9 or 10).
Canicom 800-1500-Ind J.indd 25
Gb - 25
Battery fully charged.
Weak battery: prepare to replace the battery.
Dead battery: your CANICOM 800/CANICOM 1500 switches to safety mode and
the system locks up. The battery(ies) must be replaced.
15/07/2019 11:40