How To Use The Remote Control - Num'axes Canicom 800 Manual De Instrucciones

Coding procedure:
Warning : If you have several collars, you have to code them one at a time.
1. Activate the remote control: Press the On/Off red button located on the side of the remote control
for 1 second.
2. Select the collar you want to code on the remote control:
For CANICOM 800 :
Press the A or B key in order to select the collar (the letter A or B will appear on the LCD screen).
For CANICOM 1500 :
Press the 1, 2, 3 or 4 key in order to select the collar (the number 1, 2, 3 or 4 will appear on the LCD
screen).
3. Receiver collar in position « deactivated » (off, indicator off): Approach the area where the On/Off
switch magnet is located in the remote control until coming in contact on red mark on the receiver
collar, hold for 6 seconds. The indicator on the collar lights in fixed green, then flashes in red.
4. Move the remote control away from the collar (at least 30 cm/11.81 in. apart).
5. Press the beeper button
synchronized with your remote control.
If you have several collars, renew the same procedure for each one.
Reprogram a receiver collar
Receiver collar can be re-coded indefinitely, either with the same remote control, or with a new
CANICOM remote control. Ref. coding procedure.

How to use the remote control


The CANICOM 800 remote control is designed to operate with 1 or 2 receiver collars.
The CANICOM 1500 remote control is designed to operate with 1, 2, 3 or 4 receiver collars.
Before sending any training instruction (beep sound or stimulations), you have to select the dog you
want to send a message to:
- dog A (black collar) or dog B (yellow collar) for CANICOM 800
- dog 1 (black collar), dog 2 (yellow collar), dog 3 (orange collar) or dog 4 (blue collar) for
CANICOM 1500
Canicom 800-1500-Ind J.indd 23
Gb - 23
of the remote control. A beep sound is emitted, the collar is then
15/07/2019 11:40