ADJUSTING THE WHEEL LOCKING FORCE
Minimum
To adjust the wheel locking force:
1.
Remove the screw from the center of the lock pedal.
2.
Remove the octagonal sleeve (B) from the pedal (A).
3.
Rotate the octagonal sleeve counterclockwise to increase the pedal locking force or clockwise to decrease the
locking force.
4.
Insert the octagonal sleeve (B) into the pedal (A).
5.
Reinstall the screw into the center of the lock pedal.
6.
Test the pedal locking force and verify that it holds properly before returning the chair to service.
Note: If, after adjustment, the pedal still does not hold the wheel properly, replace the wheel.
www.stryker.com
Operation Guide
Figure 38 - Wheel locking force adjustment
6250-001-161 REV D
Maximum
Return To Table of Contents
1-25
English