EN GLIS H
B-Cube
14).
figure 14
5
Insert
the
hexagonal
evaporator, pushing it in as far as it will go (see
figure 15).
figure 15
6
Fit the external coil on the evaporator
connecting its front end to the shaft of the
hexagonal coupling; each of these are hexagonal
(see figure 16).
figure 16
coupling
in
the
22
7
Assemble the container and push it towards
the back wall, making sure that it fits completely
on the seal and that its lower coupling engages
in the protruding part of the drip tray (see figure
17).
figure 17
8
Rinse with clean water so as to eliminate all
residue of sanitising solution from the bottom of
the tanks. Dry the inside of the containers with a
disposable paper napkin.
7. 4 IN-PLACE SANITIZATION
The In-Place Sanitization prior to starting the
machine may be performed, if needed, only as
f u r t h e r p r e c a u t i o n , i n a d d i t i o n t o t h e
Disassembled Parts Sanitization described
before, but never in lieu of it.
1
Prepare two gallons of a warm (45-60°C,
120-140 °F) sanitizing solution (100 PPM
available chlorine concentration or 1 spoon of
sodium hypoclorite diluted with 2 liters of water)
according to your local Health Codes and
manufacturer's specifications.
2
Pour the solution into the bowl(s).
3
Using a brush suitable for the purpose, wipe
the solution on all surfaces protruding above the
solution-level and on the underside of the top
cover(s).
4
Install the top cover(s) and operate the unit.
Allow the solution to agitate for about two
minutes. Drain the solution out of the bowl(s).
5
Use fresh product to chase any remaining
sanitizer from the bottom of the bowl(s). Drain
this solution. Do not rinse out the machine.
8 ROUTINE MAINTENANCE
1
Once a day: inspect the dispenser and
check that the product is not leaking out of the
seals. If there is any leaking, first check that the
dispenser is assembled properly. Check the
seals and lubricate them if necessary, and
replace any that are worn or defective with