Astralpool POOL BASIC Manual De Instalación página 8

Alarm
Level
OFA First Alarm (time >70%)
OFA Second Alarm (time =100%)
Flow Rate
System Error
Calibration Function
Default parameters:
Language = UK
•
Set Point value= 7,4 pH; 750 mV (Rx)
•
Dosing Method = Acid; Low (Rx)
•
Time OFA = OFF
•
Calibration = Full
•
Flow Input= OFF
•
Type dosing= PROP
•
0000137934
prog
enter
ENT CAL cal
prog
ESC esc
set MODE
Display
Level 7,2 ph
Ofa alarm 7,2 ph
Ofa stop 7,2 ph
Flow 7,2 ph
Parameter error
Error 7 ph Error 4 ph
Error 465 mv
To restore Default parameters run Following steps:
Power off Pool Basic unit
•
Keeping Press UP and DOWN Key switch on the Power.
•
The unit will flash Init.default no
•
Press up Init.default Yes
•
Enter Key to restore Default parameters.
•
rev. 1.0
Relay
Alarm Relay Close - Push Enter Key to open
Alarm Relay
- Restore Product tank
Alarm Relay open - Push Enter Key to reset
Alarm Relay Close - Push Enter Key to reset
Alarm Relay open - Restore Flow Rate
Alarm Relay Open - Press Enter Key to replace
Default parameter
- Destroy Unit
Alarm Relay open - Restore Probe or Buffer
solution and repeat calibration
function
Actions to do
6