Starting Operation - Bosch IXO Manual De Usuario

Off-Set Angle Adapter/Angle Screw Adapter (see figures C –
F)
Note: The power tool is not intended for use with the grass shears attach-
ment (1 600 A00 10D).
You can drive in screws close to edges using the off-set angle adapter (14).
The angle screw adapter (15) allows you to drive in screws in hard-to-reach
areas.
Assembly (see figures C – D)
To fit the adapters, pull off the rubber cap (3) towards you. Then the ad-
apters can be attached. The attachments can be mounted offset by 45° re-
spectively.
Removal (see figures E – F)
To remove the attachments, turn the unlocking ring (16) in the rotational
direction ➊ and pull the adapter off towards you. Then reattach the rubber
cap (3).
Operation

Starting Operation

Setting the rotational direction
The rotational direction switch (5) is used to change the rotational direction
of the power tool. However, this is not possible while the on/off switch (8) is
being pressed.
Do not use the rotational direction switch (5) when the power tool is
u
in operation, as this may damage it.
Clockwise rotation: To drive in screws, slide the rotational direction switch
(5) forward to the stop.
Anti-clockwise rotation: To loosen or unscrew screws, slide the rotational
direction switch (5) backwards.
Switching on/off
To start the power tool, press and hold the on/off switch (8).
The worklight (9) lights up when the on/off switch (8) is lightly or fully
pressed, allowing the work area to be illuminated in poor lighting conditions.
Bosch Power Tools
English | 31
1 609 92A 5LH | (07.02.2020)