Battery Power - Roadstar HRA-1500/N Manual De Instrucciones

1 English
LOCATION OF CONTROLS
1. POWER ON - OFF / VOLUME KNOB
2. AM BAND SELECTOR
3. FM BAND SELECTOR
4. DIAL SCALE LIGHT
5. DIAL SCALE
6. TUNING KNOB
7. AC CORD
8. BATTERY COMPARTMENT
9. ANTENNA
POWER SOURCES
AC POWER: You can power your portable stereo system by plugging the AC power
cord (7) into a wall power outlet. Check that the rated voltage of your appliance ma-
tches your local voltage.
BATTERY POWER: To use the radio with batteries, disconnect the AC power cord
and insert 6 × "LR14" batteries into the compartment (8). Be sure that the batteries
are inserted correctly to avoid damage to the appliance. Remove the batteries when
the radio will not be used for a long period of time, as this will cause leakage to the
batteries and subsequently damage to your radio.
TO USE THE RADIO
1. Rotate the [Volume Knob] (1) clockwise to power ON the unit;
2. Choose the radio wave band using the [AM/FM Band] button (2/3);
3. Adjust radio frequency to your desired station by turning the [Tuning Knob] (6);
4. Adjust the volume with the [Volume knob] (1);
5. To switch off the radio, rotate the [Volume Knob] (1) completely counter-
clockwise.
Note: For a better reception of FM radio, reorient the antenna
Note: Press the [Light] button (4) to switch ON the Dial Scale illumination.
TECNICAL SPECIFICATIONS
Power
Power Input:
Radio Frequency Coverage
FM:
AM:
Speaker
Output Power:
Specifications and design are subject to possible modifications without notice due to
improvement.
AC 230V ~ 50Hz.
DC 9V = (6 x "LR14" Batteries).
87.5 - 108 MHz.
520 - 1620 KHz.
1 x 1.5 Wrms.
(9).